One of the most serious sorts of damage that your car might suffer is gunshot holes. It not only detracts from the appearance of your vehicle, but it also raises too many concerns regarding how you came to have your vehicle photographed in the first place. So, if you don’t want to draw unwanted attention to yourself, you need to know what to do if your automobile has bullet holes – how to fix them and what costs you can incur in the process.
Repairing bullet holes in your car is similar to repairing any other type of hole or small ding in your car. Applying filler, contouring, smoothing, priming, and painting are the main stages. It’s not difficult, and it’ll only set you back a few dollars. How to Fix a Bullet Hole in Car is similar to repairing any other type of hole or small ding in your car. Applying filler, contouring, smoothing, priming, and painting are the main stages.
It’s not difficult, especially if you’ve worked on automobiles before. When opposed to having it repaired in an auto shop, it would most likely cost you close to nothing.
Fixing it, on the other hand, is dependent on the size of the bullet hole. Some bullet wounds are simple to repair, while others require a more involved procedure.
Read More: How to Measure Car Speaker Size
Follow the steps to Repair Bullet Holes in Car :-
1. Purchase a Body Filler Kit
There are a variety of treatments on the market for fixing dents, gunshot, and minor holes in your vehicle’s surface. At least two chemicals are commonly included in these body filler kits. These include both the filler and the hardener, which should be mixed with the filler before use.
Select a Filler with the Simplest Directions.
When purchasing a body filler kit, choose one with the most straightforward instructions. That way, you’ll be able to do the assignment with minimal effort. Some products are designed for sheet metal repairs, such as filling in holes and other punctures. Before priming and painting, they can even out spots on a car’s body panel.
2. Clean and sand the Area of bullet hole
You must first carefully clean the body area before putting the filler to the holes. After that, sand the area with aluminum oxide sandpaper, either #180 or #220. You can also use any sandpaper that works well on your car’s plastic or aluminum parts.
A Scotch-Brite pad can also be used. Remove the sanding dust from the region around the bullet hole by scraping it away.
3. Filler: Mix and Apply
Begin mixing the filler with the hardener after the body area has been completely cleaned and sanded. Make sure you follow the kit’s instructions. Only make as much of the hardener-filler combination as you’ll need right immediately. Then whisk it until it’s a consistent hue.
Maintain the Filler’s Position
Place something underneath the hole to keep the filler in place while you’re mending it. Under the hole, you can use either fiberglass screening or fine metal chicken wire. This is effective in the body’s metal parts. Make sure it’s positioned correctly on the body’s underside.
4. Shape, smooth, prime, and paint
For drying, use the sunlight or a heat lamp. Allow the filler to firm to a consistency similar to hard cheese. Then, using a perforated file, scrape it down to about the same level as the paint.
Wait at least 10 to 15 minutes, and no more than 20 to 30 minutes, until the filler is completely dry. After everything has been smoothed and evened out, the filled-in area must be primed. Apply the Primer in Several Layers. Apply a few coats of primer, then sand each one. Retouch the paintwork. After the primer has dried fully, all that’s left is to touch up the paint, which should be rather simple from here on out.